Inquiry
Inquiry
M6si uses the unique Surface MountDesign design of Musical FidelitY, which greatly reduces the area of the circuit board and makes the arrangement inside the enclosure more flexible. The rear and front circuits of M6si are naturally separated, and the two channels in the rear are also separated into two independent power modules. Previous models did not have such a design, which is one of the obvious improvements of M6si.
This makes the M6si sound like a front stage with two mono rear stages, rather than a typical merger machine. Although the power output of M6i is already very good, M6s&# 39; I went even further, reaching 220W per channel (8Q), which is 20W more than M6i. M6si also has built-in MC/MM playback and a 24bit/96kHz USB decoding interface, making it convenient for users to connect to a computer. At the same time, it also supports bypass input for home theaters, enriching its functions.
| Output | |
| power | 220 watts/per channel/8 ohms |
| Voltage | 42 volts RMS, 20Hz -20 kHz; Sound cutting occurs |
| 120V peak to peak current 45A peak to peak | |
| Damping factor | one hundred and eighty |
| Output configuration | 2 pairs per channel |
| Linear input | |
| Total harmonic distortion+noise | < 0.007% typical, 20Hz - 20 kHz |
| Signal to noise ratio | > 107dB 'A' weighted |
| Input impedance | 40 k ohms |
| frequency response | + 0, – 0.1dB, 10Hz - 20 kHz |
| Player input | |
| Sensitivity (MM) | 3mV nominal |
| (MC) | 0.4mV nominal |
| Signal to noise ratio | > 84dB A 'weighted |
| Input impedance | 47k ohms (MM and MC) |
| frequency response | RIAA/IEC ±0.5dB |
| 20Hz-20kHz | |
| USB Input | |
| USB | Asynchronous, with a high sampling rate 24 bit, 96 kHz USB audio stream |
| Connect | |
| USB input | Type B interface, up to 24 bit 96kHz USB audio stream |
| Turntable input | 1-Pair Singer MM Input |
| Ground wire pole of turntable | 4mm banana pole to chassis grounding |
| Line level input | 4 pairs of line level RCA terminals |
| 1 pair of line level balanced XLR terminals | |
| Line level output | 1 pair of RCA terminals with constant line level output |
| 1 pair of line level RCA terminals, preamplifier output such as dual amplifiers | |
| Speaker output | 2 pairs of 4mm banana plugs/terminals |
| Power Requirements | |
| Main power supply | 115/230VAC 50/60Hz (factory preset) |
100VAC 50/60Hz (optional) | |
| Power consumption | < 0.5W (standby mode) 58W (normal) 680 W (maximum) |
| Weight | |
| Net weight of the aircraft body | 16.6 kg (36 1/2 pounds) |
| Gross weight including packaging box | 21.3 kg (47 pounds) |
| Size | |
| wide | 440 mm (17⅓”) |
| High (including feet) | 125 mm (5”) |
| Deep (front back) including wiring ports | 400 mm (15¾”) |
